English Manual - Kinor-35H movie camera

This manual has been carefully translated from the Russian original manual. This is Part 1 of two. I just don't have the Part 2 containing electrical diagrams. But I think that it is not very useful, as it is too complex device to try to repair it yourself.

Unfortunately, one page missing in the Maintenance section, and one picture missing (showing the camera with the 150m mag and the mag tilt). All other info (text and pictures) included.

Here is table of contents (to give you an idea of what is covered in the manual):

1. INTRODUCTION
2. PURPOSE
3. TECHNICAL SPECIFICATION
   3.1. Movie Camera
   3.2. Light Metering Device
   3.3. Shooting Speeds Unit
   3.4. Shooting Mode Indication Unit
   3.5. Video Signal Conversion Unit (BPV)
   3.6. Voltage Conversion Unit (BPN)
   3.7. Synchronization Unit
   3.8. Network Power Supply Unit
   3.9. Thermoregulator
4. CONFIGURATION
5. CONSTRUCTION AND OPERATION OF THE CAMERA
   5.1. The kinematics of the "KINOR-35N" camera.
   5.2. The optical schematics of the "KINOR-35N" camera.
6. CONSTRUCTION AND PRINCIPLE OF WORK OF THE MAIN PARTS
   6.1. The camera
   6.2. The mags
   6.3. The viewfinders
   6.4. The lenses
   6.6. The start-up device
   6.7. The follow focus devices
   6.8. The brackets
   6.9. The network power supply
   6.10. The light metering device
   6.11. The video assist set
   6.12. The controller
   6.13. The video signal conversion unit
   6.14. The voltage conversion unit
   6.15. The shooting frequency unit
   6.16. The shooting mode indication unit
   6.17. The synchronization unit
   6.18. The thermo regulator
   6.19. The bridge plate set
7. MARKING AND SEALING
8. PACKAGE
9. THE OPERATION GUIDELINES
10. THE SAFETY GUIDELINES
11. PREPARATION FOR WORK
   11.1. Preparation of the controller
   11.2. The mag loading
   11.3. Loading the camera
   11.3a. Installing and removing of the front and rear film gate.
   11.4. Mounting a lens
   11.4a. Installation of the viewfinder
   11.5. Mounting the one-side follow focus
   11.6. Mounting the compendium
   11.7. Mounting the video assist set
   11.8. Mounting the light metering device and preparation it for work
   11.9. Preparation of the batteries
   11.10. Operating the network power supply unit
   11.11. Operating the camera from the external sync signals and sending the start marker signal
   11.12. Heating
12. CONTROLLING THE CAMERA
   12.1. Start and stop the camera.
   12.2. Operating the lenses
13. TROUBLESHOOTING
14. MAINTENANCE
   14.1. Cleaning the camera
   14.2. Cleaning the optics
   14.3. Cleaning the shutter
   14.4. Lubricating
   14.6.2. The 300m mag
14a. PRESERVING
   14a.1. Preparation for preserving
   14a.2. Preserving
14b. DEPRESERVATION AND RE-PRESERVATION
15. STORAGE RULES
16. TRANSPORTING